The Orlimar V18 Driver offers a fresh new twist on adjustable driver performance for all levels of golfers. What makes it so unique?
First, it is constructed from a new aerospace alloy material (8-1-1 Titanium) that is 10% lighter than what typical 6-4 titanium drivers are made from as well as an improved strength to weight ratio. The skeletal soled body and the ultra-thin crown (0.8mm thick) drastically reduces the overall weight while providing the foundation to a low center of gravity design. The importance of this is it increases the amount of discretionary weight allowable for adjustability.
The key feature of the Orlimar V18 driver is an 8-position rotatable sole which weighs an enormous 35 grams including an offset tungsten weight. The offset tungsten weight on the sole shifts the center of gravity when rotated which alters the ball flight or what we call D.I.A.L. You can increase the MOI and launch angle by rotating the red line on the dial sole to the rear, reducing spin by moving that red line to the face or create fades or draws by placing it in the toe or heel positions. In seconds, one can fine-tune the V18 dial sole to suit the player's needs.
The Orlimar T20 Torx wrench (which is included) will allow you to loosen the dial and place it in any of the pre-set positions and re-tighten. Make sure to read and follow all the operating instructions. The Orlimar V18 driver Conforms to the Rules of Golf.
Features and Specifications
Right Hand Only
Head Material: 8-1-1 Titanium
Head Volume: 442cc
Standard Loft Angles: 9.5°, 10.5°
Standard Face Angles: 0° Square (9.5°), .5° Closed (10.5°)
Standard Length: 45" on both